Self Aligning Ball Bearings
A self-aligning bearing is recommended when the alignment of the shaft and housing is difficult or when the shaft may bend during operation. Brda notes that similar to deep groove ball bearings, most self-aligning ball are for general use.
Depending on the series, most self-aligning bearings can be interchanged with standard ball bearing assemblies. (6200 and 6300 have direct interchanges with the 1200 and 1300 series). “However, if this is not possible, the self-aligning bearing may be wider or can have a tapered bore,” Brda explains.
Normal mounting and handling procedures for a cylindrical bore bearing should be followed. For the tapered bore, special care must be taken to ensure the bearing is driven up the taper the appropriate amount. Because matching the bearing to the specific application is critical, it is important to verify your application need with your selected vendor.
- 40 mm x 90 mm x 23 mm NSK 1308 self aligning ball bearings
- In Stock
- 140mm
- 50 mm x 110 mm x 62 mm NKE 11310 self aligning ball bearings
- 45 mm
- HMV 11 E
- 50 mm x 110 mm x 40 mm NACHI 2310K self aligning ball bearings
- Steel
- Open Type
- 15,875 mm x 46,038 mm x 15,88 mm SIGMA NMJ 5/8 self aligning ball bearings
- 89.297 mm
- 177.8 mm
- 20 mm x 47 mm x 18 mm NTN 2204S self aligning ball bearings
- In Stock
- 140mm
- 25 mm x 52 mm x 15 mm NTN 1205SK self aligning ball bearings
- In Stock
- 140mm
- 90 mm x 190 mm x 43 mm KOYO 1318 self aligning ball bearings
- 89.297 mm
- 177.8 mm