Self Aligning Ball Bearings
A self-aligning bearing is recommended when the alignment of the shaft and housing is difficult or when the shaft may bend during operation. Brda notes that similar to deep groove ball bearings, most self-aligning ball are for general use.
Depending on the series, most self-aligning bearings can be interchanged with standard ball bearing assemblies. (6200 and 6300 have direct interchanges with the 1200 and 1300 series). “However, if this is not possible, the self-aligning bearing may be wider or can have a tapered bore,” Brda explains.
Normal mounting and handling procedures for a cylindrical bore bearing should be followed. For the tapered bore, special care must be taken to ensure the bearing is driven up the taper the appropriate amount. Because matching the bearing to the specific application is critical, it is important to verify your application need with your selected vendor.
- 30 mm x 62 mm x 16 mm ISO 1206K self aligning ball bearings
- Steel
- Open Type
- AST 2214 self aligning ball bearings
- 2950
- 1540 mm
- AST 2202 self aligning ball bearings
- 0.072
- 3.25
- 65 mm x 120 mm x 31 mm NKE 2213 self aligning ball bearings
- Steel
- Open Type
- Toyana 1300 self aligning ball bearings
- 45 mm
- HMV 11 E
- 25 mm x 52 mm x 15 mm NKE 1205 self aligning ball bearings
- Steel
- Open Type
